Dell Inspiron 16 7610 Service Manual page 55

Steps
1. Place the system board on the palm-rest and keyboard assembly.
2. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the system board to the palm-rest and keyboard assembly.
4. Replace the screw (M2x2) that secures the system board to the palm-rest and keyboard assembly.
5. Place the Type-C port-bracket on the system board.
6. Replace the two screws (M2x5) that secure the Type-C port-bracket to the system board.
7. Connect the power-adapter port cable to the system board,
8. Adhere the tape that covers the power-adapter cable-connector on the system board.
9. Connect the keyboard-backlight cable to the connector on the system board and close the latch.
10. Connect the keyboard cable to the connector on the system board and close the latch.
11. Connect the touchpad cable to the connector on the system board and close the latch.
12. Connect the speaker cable to the system board.
13. Connect the I/O-board cable to the connector on the system board and close the latch.
14. Connect the display cable to the connector on the system board.
Next steps
1. Install the heat sink.
2. Install the left fan.
3. Install the right fan.
4. Install the battery.
5. Install the wireless card.
6. Install the M.2 2230 solid-state drive
7. Install the M.2 2230 solid-state drive
8. Install the memory.
9. Install the base cover.
or M.2 2280 solid-state drive
into M.2 slot two.
into M.2 slot one, whichever applicable.
Removing and installing components 55