Advertisement
Transportation
1. When you hand-carry the product, covers over the cutting part are necessary; lift up the product
and carry it paying attention to the blade.
2. Never transport the product over rough roads over long distances by vehicle without removing
all fuel from the fuel tank. If doing so, fuel might leak from the tank during transport.
Fuel
WARNING:
Gasoline is very flammable. Avoid smoking or bringing any
flame or sparks near fuel. Make sure to stop the engine, and allow it cool down
before refuelling the unit. Select outdoor bare ground for fuelling, and move at
least 3 m (10 ft) away from the fuelling point before starting the engine.
Gasoline requirements
•
All 2-stroke products are powered by professional-commercial duty, hi-performance, hi-RPM,
air cooled 2-stroke engines.
•
Hi-performance 2-stroke engines produce higher HP outputs as compared to standard home
owner duty or light commercial duty production engines offered by most manufacturers. Exhaust
emission are controlled by the fundamental engine parameters and components (eq., carbure-
tion, ignition timing and port timing) without addition of any major hardware or the introduction
of an inert material during combustion.
Gasoline/oil mixture storage recommendations
Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to
limit the entry of moisture and additional air (oxygen). Moisture and air cause the development of varnish
and gum, making the fuel stale. Stored gasoline and gasoline/oil mixture ages and loses its octane rating
and volatility. Do not mix more gasoline/oil than you intend to use in 30 days, and 60 days when fuel
stabilizer is added.
How to mix fuel
Recommended mixing ratio gasoline/oil 40:1. Pay attention to agitation.
1. Measure out the quantities of gasoline and oil to be mixed.
2. Put some of the gasoline into a clean, approved fuel container.
3. Pour in all of the oil and agitate well for 10 s.
4. Pour in the rest of gasoline and agitate again for at least 1 min. As some oils may be difficult to
agitate depending on oil ingredients, sufficient agitation is necessary. Be careful that, if the ag-
itation is insufficient, there is an increased danger of early piston seizure due to abnormally lean
mixture.
5. Place a clear indication on the outside of the container to avoid mixing up with gasoline or other
containers that do not contain oil.
6. Indicate the contents on outside of container for easy identification.
Fuelling the unit
1. Untwist and remove the fuel cap. Put the cap on a clean surface.
2. Put fuel into the fuel tank to 80 % of the full capacity.
3. Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61493
Page 9
06
2021-1
Advertisement
