Advertisement
Reduction gearbox (MA8)
Refill gear housing every 25 working hours. Use grease pump. Feed grease until
it comes out of the base of blades.
Procedures to be performed after every 100 hours of use (M9)
1. Remove the muffler, insert a screwdriver into the vent, and wipe away any
carbon build-up. Wipe away any carbon build-up on the muffler exhaust
vent and cylinder exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way in between the clutch
lining and drum, and if so, wipe it clean.
Storage
1. Oil the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug and pour a small amount of oil into the cylinder.
4. Rotate the crankshaft several times using the starting rope in order to distribute the oil. Put the
spark plug back in.
5. Wrap the engine with a plastic sheet.
6. Store the trimmer in a dry place, preferably not in direct contact with the floor and away from
heat sources.
Disposal
When disposing your machine, fuel or oil for the machine, be sure to respect all local regulations.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61493
Page 15
06
2021-1
Advertisement
