Advertisement
Before starting the engine
1. The area within a perimeter of 15 m (50 ft) of the person using the product should be considered
a hazardous area into which no one should enter. If necessary, yellow warning rope and/or
warning signs should be placed around the perimeter of the area. When work is to be performed,
care should also be taken to constantly look around or otherwise check for the presence and
locations of other people working so as to maintain a distance between each person sufficient
to ensure safety.
2. Check the condition of working area to avoid any accident by hitting hidden obstacles such as
stumps, stones, cans, or broken glass.
3. Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the cutting attach-
ment is properly installed and securely fastened.
Starting the engine
1. Keep bystanders, especially children, and animals at least 15 m (50 ft) away from the operating
point. If you are approached, immediately stop the engine.
2. The product is equipped with a centrifugal clutch mechanism; so the cutting attachment might
begin to rotate as soon as the engine is started. When starting the engine, place the product
onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the
cutting part nor the throttle come into contact with any obstacle when the engine starts.
WARNING:
3. After starting the engine, check to make sure that the cutting attachment stops rotating when
the throttle is moved fully back to its original position. If it continues to rotate even after the
throttle has been moved fully back, turn off the engine and take the unit to your authorized
servicing dealer for repair.
Using the product
IMPORTANT:
Cut only materials recommended by the manufacturer, and only use the device for
1. Grip the handles firmly with both hands using your whole hand. Place your feet slightly apart
(slightly further apart than the width of your shoulders) so that your weight is distributed evenly
across both legs, and always be sure to maintain a steady, even posture while working.
2. Maintain the speed of the engine at the level required to perform cutting work, and never raise
the speed of the engine above the level necessary.
3. If the unit starts to shake or vibrate, turn off the engine and check the whole unit. Do not use
it until the trouble has been properly corrected.
4. Keep all parts of your body away from rotating cutting attachment and hot surfaces.
5. Never touch the muffler, spark plug, or other metallic parts
of the engine while the engine is in operation or immedi-
ately after shutting down the engine. Doing so could result
in serious burns or electrical shock.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
IMPORTANT:
Remove any obstacle before beginning work.
Never place the throttle into the high-speed position when starting the en-
gine. Never start the engine at the cutting attachment side.
tasks explained in the manual.
Item 61493
Page 7
06
2021-1
Advertisement
