Advertisement
3. Slide the ignition switch to the engine side to set it in the ON position
(OP3).
4. Rest the unit on a firm place. Pull the starter knob quickly (OP4).
NOTE:
Avoid pulling the rope to its end or returning it by releasing the knob.
Such actions can cause starter failures.
5. When the engine has started, gradually open the choke.
6. Allow the engine to warm up for half a minute before starting operation.
NOTE:
If the engine would not start after several attempts, open the choke
and repeat pulling the rope or remove the spark plug and dry it.
Stopping the engine
1. Release the throttle lever and run the engine at idling speed for half a minute.
2. Slide the ignition switch to the STOP position.
IMPORTANT:
Except for an emergency, avoid stopping the engine while pulling the throttle lever.
NOTE:
If the engine would not stop when setting the ignition switch to the stop position, close the
choke lever and stop the engine. In this case, please have the machine repaired at a qualified workshop.
Adjusting idling speed
When the engine tends to stop frequently at idling mode, turn the idle set screw clockwise.
NOTE
1. Idle set screw is (1).
2. When the cutting blades keep moving after releasing the throttle trigger, turn the idle set screw
counter-clockwise. Warm up the engine before adjusting the idling speed.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61493
Page 11
06
2021-1
Advertisement
