Draper Patriot Motorized Flag 500101 Instructions Manual

Draper Patriot Motorized Flag 500101 Instructions Manual

Advertisement

Quick Links

Patriot Motorized Flag
Vertical - 500101
TOOLS REQUIRED
POWER DRILL
PENCIL
Contents
PLEASE READ - Safety Information ....................................................................2
Section 1 - Hanging Motorized Flag ...................................................................3
Section 2 - Bottom Patriot Panel Installation/Removal ..................................4
Section 3 - Operation............................................................................................4
Section 4 - Electrical Connections .....................................................................5
Section 5 - Limit Adjustments .............................................................................5
Position and Manner of Display of US Flag
• Flag should be oriented to display the field of stars to the observer's uppermost left.
• If the building has one main entrance, flag should be suspended vertically and oriented
• If the building has more than one main entrance, the flag should be suspended vertically
• If the building has entrances in more than two directions, flag should be located near the
TAPE MEASURE
HARDWARE
(by others)
Horizontal - 500102
When displayed either horizontally or vertically against a wall:
When displayed away from the wall or in the middle of a room:
with the field of stars to the observer's uppermost left upon entering.
near the center of the room and positioned with the field of stars to the upper north corner
if entrances are east and west, or with the field of stars to the upper east when entrances
are north and south.
center of the room and should be oriented to display the field of stars in the upper east corner.
CAUTION
Read and understand all
warnings
beginning installation.
LEVEL
Section 6 - Case Length Dimensions .................................................................6
Vertical Case Length - 500101 ...........................................................................6
Horizontal Case Length - 500102 .......................................................................7
Section 7 - End of Case Dimensions ..................................................................7
Section 8 - Ceiling Mounting Bracket Dimensions ..........................................8
Section 9 - Wall Mounting Bracket Dimensions ...............................................8
INSTRUCTIONS
INSTALLATION & OPERATION
Source: The American Legion
before
(Page 2)
If you have any difficulties installing or servicing your
Patriot Motorized Flag, call your dealer or Draper, Inc.
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385
draperinc.com | 765.987.7999 | 800.238.7999
|
© 2021 All Rights Reserved
FORM: Patriot_Inst21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Patriot Motorized Flag 500101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Draper Patriot Motorized Flag 500101

  • Page 1: Table Of Contents

    Section 9 - Wall Mounting Bracket Dimensions ..........8 If you have any difficulties installing or servicing your Patriot Motorized Flag, call your dealer or Draper, Inc. Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385 draperinc.com | 765.987.7999 | 800.238.7999 © 2021 All Rights Reserved...
  • Page 2: Please Read - Safety Information

    3. Do not affix the unit to walls or ceilings that have inadequate strength 13. Do not wire motors in parallel without written permission from Draper, Inc. to permanently hold the unit during use. It is the owner’s and installer’s 14.
  • Page 3: Section 1 - Hanging Motorized Flag

    Patriot Motorized Flag page 3 of 8 Section 1 - Hanging Motorized Flag Figure 1-A HOISTING BRACKET not to be used for Section 1.1 - Ceiling Installation final installation ⁄ CASE " PLEASE NOTE: It is the installer’s responsibility to make sure appropriate fasteners are MOUNTING used for mounting.
  • Page 4: Section 2 - Bottom Patriot Panel Installation/Removal

    Patriot Motorized Flag page 4 of 8 Section 2 - Bottom Patriot Panel Installation/Removal Bottom flange of Bottom access panel secures to the Motorized Flag Access housing housing with two screws , and held in the (one on each end) closed position by engagement brackets with ball detents Bottom Access Panel Door that snap into case support brackets...
  • Page 5: Section 4 - Electrical Connections

    Please check 1. Raise flag surface approximately 1' above desired setting (30 cm) down travel. with Draper prior to resetting flag and turn off. limits. 2. Turn DOWN limit screw clockwise (3 screw turns = 1/2 roller revolution) 3.
  • Page 6: Section 6 - Case Length Dimensions

    Patriot Motorized Flag page 6 of 8 Section 6 - Case Length Dimensions Vertical Case Length - 500101 CASE LENGTH: 13' 5 ¾" (4M) 18" 18" (457mm) (457mm) ¾" ¾" (19mm) (19mm) (5.49M) (3.66M) • For minimum length of ceiling cutout: subtract 1 1/4" from case length (32mm) (measured from outer edge of flanges)
  • Page 7: Horizontal Case Length - 500102

    Patriot Motorized Flag page 7 of 8 Horizontal Case Length - 500102 CASE LENGTH: 19' 5 ¾" (5.92M) 18" 18" (457mm) (457mm) ¾" ¾" (19mm) (19mm) (3.66m) (5.49M) • For minimum length of ceiling cutout: subtract 1 1/4" from case length (32mm) (measured from outer edge of flanges) •...
  • Page 8: Section 8 - Ceiling Mounting Bracket Dimensions

    Patriot Motorized Flag page 8 of 8 Section 8 - Ceiling Mounting Bracket Dimensions " 2 " 2 " R " (73mm) (73mm) (5mm) (13mm) (11mm) (13mm) " 1 " (3 mm) (38mm) (11.1mm) " (6mm) " " 2 " 3 "...

This manual is also suitable for:

Patriot motorized flag 500102

Table of Contents