Blue Wave NB19790 Instructions Manual page 9

8. Carefully slide the Horizontal Beams 2
into the sleeves of the pool.
2
2
10. Insert the Pins 6 down through the top of the T-Fittings
until the Pins snap into place on the lower side of the
T-fitting.
6
12. Look through the hole in the T-fitting, as you insert the Vertical
Leg rotate it until the buttons align with the holes and pop out,
locking the Vertical Leg in place. Do this for all Vertical Legs.
Note: Each vertical leg has a V-Shaped
Spring Pin
extra included with your pool parts.
pre-installed. There is one
7
OWNER'S MANUAL
9. Connect all of the T-Fittings 4 to the Horizontal Beams 2.
IMPORTANT: DO NOT go on to the next step until all of the
T-Fittings have been connected to all of the Horizontal Beams.
4
4
11. Carefully slide the Vertical Legs 3 up through the belt that runs
around the middle of the pool.
Tips: For smaller pools without a belt, slide the vertical legs up
through the sleeves on the pool wall.
3
13. Go around and check that all fittings, legs, and beams are
properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
3
9