Power Cable Installation - Motorola PMLN7018 User Manual

01_EN.fm Page 8 Monday, March 28, 2016 10:08 AM
2. Push the Adaptor Holder Top to engage onto the Adaptor
Holder bottom.
3. Secure the Adaptor Holder onto the bottom of the cradle
pocket by screwing the jack screws into the insert nuts.
Figure 5. Installing the Vehicular Power Module onto the
When installing the PMLN6182 Vehicular Charging Cradle
with VPM Kit, follow the following procedure. See Figure 5 :
1. Secure the Vehicular Power Module onto the bottom of
the cradle pocket by screwing the jack screw onto the
insert nut.
Note: Do not connect the power cable to the cradle until the
power cable is fully installed.

POWER CABLE INSTALLATION

Note: This installation procedure is applicable to PMLN6182
Vehicular Charging Cradle with VPM Kit only. The
PMLN6182 Vehicular Charging Cradle with VPM Kit
supports 12/24 VDC vehicular batteries only.
The Vehicular Charger Kit power cable is equipped with
5-Ampere fuse for battery positive terminal and 1-Ampere
fuse for ignition. Verify that the vehicle electrical system can
Jack Screw (x2)
cradle.
8
Insert Nut
(x2)
Vehicular Power
Module(0104058J87/
PS000149A01)