Emist EX-7000 Manual page 12

EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL
INSPECTION &
SET UP
ASSEMBLY & ASSEMBLY &
OPERATION OPERATION
INSTRUCTIONS INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE
& CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
12
ASSEMBLY & OPERATING INSTRUCTIONS
ASSEMBLY INSTRUCTIONS AND TIPS
1. RECHARGEABLE BATTERY:
The system uses up to two lithium-ion batteries.
a. The battery should be fully charged prior to the start of a
project.
b. Inspect the battery for any debris or damage prior to inserting.
c. The indication bar at the end of the battery will light up to show
remaining charge (3 bars = full charge).
d. One bar during startup may limit time of use without charging.
e. The connector side of the battery enters the power pack case
with the release latch facing up.
f. The battery easily sits in the power pack. Over applying
pressure may make the battery difficult to remove without
causing overall damage.
2. INTERCHANGEABLE 3.1 LITER LIQUID TANK:
a) Remove the vented cap, leaving strain filter in place.
b) Fill as needed and replace vented cap.
c) Utilize liquids for duration of project or until refill is
required.
d) You may exchange tanks with different liquids at
any time after flushing the system.
IMPORTANT: DO NOT DROP TANK INTO THE TANK
WELL. CAREFULLY SLIDE THE TANK BACK INTO
THE POWER PACK TANK WELL UNTIL IT LOCKS/
CLICKS INTO PLACE.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921
Keep the battery release
button facing upwards as it
slides into the battery ports.