Installation instructions - only Jablotron distributor certified installers should install this kit.
•
Detailed manuals for all included components can be found on the enclosed CD or on the Jablotron website
•
www.jablotron.com
1. Kit contents
All items in the kit are enrolled and preprogrammed. The
detectors and remote controls have batteries pre-installed.
Item
description
JA-60N
wireless door sensor
JA-60P
wireless motion detector
JA-63F
wireless keypad
RC-44
remote control
UC-260
wireless indoor siren
The RC-42 is the same remote control as the RC-44 except
that it is built into a housing with only two buttons (
have identical functions to the left pair of RC-44 buttons.
2. Before installation
Decide upon suitable locations for all of the devices. The
wireless keypad should be within 20m of the control panel.
There should be power and a telephone line available for the
control panel.
JK-16 PROFI
JK-16 PROFI
a) Install the control panel - see the drilling template on the
b) Install and connect the backup battery to the control panel
address
c) Connect the AC power to the control panel
1
d) The Green LED should flash in the control panel
2
c1
e) Connect the keypad's batteries (pull out the red tape to
c2
panel is enrolled
&
), which
RESET
Green LED
1/4
3. Control panel installation
last page of this manual.
activate batteries). P will be indicated on the keypad
(programming mode).
• If F is indicated, there is no communication with the control
panel.
• Enter F0 6060 to re-enter P mode if you accidentally exit it
by pushing the N key
To save the keypad batteries, close its cover.
MGK24401