Advertisement
№ Name
1
Tool
2
Leader hose
3
Coupler
4
Recoil hose
5
Water separation
Tools used
Only use sockets and adapters that are in perfect condition. The sockets and adapters provided for
this pneumatic tool are specified as square drive sockets in the technical data table.
Safety
When working with this device, always wear suitable eye, hearing and mouth protection as
well as gloves in order to minimize the risk of injury.
The workplace must be well ventilated.
Release the on/off switch if the power supply and the compressed air supply fail.
Operation
On/off switch
The switch is located inside or outside of the handle. It is a dead man's switch. As soon as you release
the trigger, the tool will stop rotating. Wait a few moments until the tool has stopped rotating com-
pletely. For safety reasons, place it on a flat surface or in a holder.
Speed adjuster
You can freely set the speed in three steps by turning the rotary knob. 1 is the lowest speed, 3 the
highest.
Direction of rotation
Make sure that the direction of rotation is correct before operating the tool. The letter "F" indicates for-
ward rotation, the letter "R" indicates reverse rotation. Forward rotation always refers to a clockwise ro-
tation from the point of view from operator.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№ Name
6
Air supply
7
Drain valve (Drain daily!)
8
Regulator
9
Oiler
10 Nipple
Item 61900
Page 6
03
2021-1
Advertisement
