Advertisement
Technical specifications
Idel speed (rpm)
Bolt diameter (㎜)
Air pressure range (bar)
Air inlet opening (i n ch)
Max. torque (Nm)
Gear
Square Drive Size (㎜)
Weight (㎏)
Accessories
CAUTION:
When working with the air impact wrench, hearing protection must be worn. Some noise
caused by this device is unavoidable. In the case of complex work it is advisable to plan the tasks and,
if necessary, observe rest periods. Working hours must be limited to the bare minimum. Ear defenders
must be worn for personal protection.
Product description
This tool has a reversible spindle that drives a hammer. This hammer periodically hits an anvil that in -
cludes a drive adapter. This is intended to tighten or loosen screws and nuts without the power tool
causing a major torque reaction.
Use
This product is the perfect assembly tool for working on cars, trucks, boats, construction equipment,
excavator steel chains and more.
Air line
Use a ¼" air hose to connect the compressor and the tool. The compressed air is cooled and the wa-
ter it contains is separated when the air leaves the compressor. However, some of the water con-
denses in the pipeline and can get into the mechanism of the tool. This may lead to malfunctions of the
device. Install an air filter and oiler between the compressor and the tool. Use a compressor with 3 hp
or more for each tool.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
4200
41
6–10
½
2380
Square drive
25.4 (1")
17
1 × air impact wrench
2 × sockets (32 mm, 33 mm diameter)
1 × hexagon key
1 × handle (additionally attachable)
1 × fitting
1 × plastic case
Item 61900
Page 5
03
2021-1
Advertisement
