Table of Contents
Advertisement
• High/Low Quality (LQ) : When "LQ" is displayed, pressing "OK" will set the camera to low
resolution mode (320x240 pixels)-the "LQ" icon will stop blinking. LQ mode will allow you to fit
more photos in the memory before you stop to download them, with the tradeoff of less quality
per photo. To reset the camera to high resolution, return to the LQ mode, and press SNAP again
("LQ" will no longer be displayed). When the LQ icon is off, the camera is in high resolution mode
(640x480 pixels) for best quality.
• AVI Mode: (
photos. After this mode has been activated (press SNAP when the movie icon blinks), holding down
the SNAP button will film an avi movie until you release it (or the memory is full). When the SNAP
button is released, the camera reverts back to normal still photo operation (assuming unused memory
remains). Repeat the steps to set AVI mode again if you wish to shoot more movie clips.
• Power Frequency Setting: (60/50 Hz): This sets the correct electrical frequency to avoid any
"flickering" in the camera's output. The normal default is "60" Hz (cycle), as used in the United
States. If you are using the camera in a country with 50 Hz power frequency, press SNAP when the
"50" icon blinks to select it.
• Delete Last (
) : Pressing SNAP when the "Delete Last" icon is blinking will delete (erase) the last
photo you took from the camera's memory.
• Delete All (
) : When this mode is selected, the word "ALL" appears next to the trash can icon, and
the number of total photos in memory will blink in the display. Press and hold the SNAP button to
) : This mode sets the camera to take short movie clips (.avi files) rather than still
3
Advertisement
Table of Contents
