Inflating The Seats; Positioning The Seats On The Bottom; Fins; Maintenance After Use - Decathlon Kayak Itiwit X100 2P Manual

1.3 Inflating the seats

• Connect the ITIWIT pump (sold separately) using the small diameter conical pump end and inflate the seats to 3 PSI.

1.4 Positioning the seats on the bottom

• Position the seats on the bottom using the riptab areas under the seat and on the bottom. (*5)
• Slip the bags or equipment you need into the kayak's rear storage area or attach to the rear deck.

1.5 Fins

• Slide the fins into the base and clip them in using the pin (*6)
• The boat is ready for launch.
2. CARE, PACKING AWAY AND STORAGE
Corrosive liquids such as battery acid, oil, petroleum and acetone can damage the product.
In case of contact with these products, rinse the kayak with fresh water.

2.1Maintenance after use

• Remove the seats and slightly deflate the bottom to facilitate rinsing.
• Rinse the kayak, bottom and seats with clean water after each use to avoid damage from sand, salt water and sun.
Open the drain plugs located in the middle of the kayak and at the back. Tilt the kayak to empty the water.
2.2 Drying
• Wipe the inside and outside of the kayak and the seats and bottom with a sponge or towel.
INSTRUCTIONS
PLEASE NOTE: if the kayak is not in use and remains in direct sunlight, it can become seriously damaged.Check the pressure regularly and deflate the kayak if
necessary.
2.3 Folding
• Make sure the folding surface is clean
• Remove the fins. (*7)
• Deflate the side tubes by pressing the plunger of each valve. The valves are located at the back of the kayak. (*8)
PLEASE NOTE: Do not unscrew the pressure relief valves at the front.
• Fold the bottom. Start folding from the front to flush out the air through the valve. Make the first fold on the edge of the EVA foam. (*9)
• Fold the rest of the kayak in half along the longitudinal axis. Put the front fin base flat.(*10)
• Lay the rolled-up bottom on the front end. Roll the whole thing together to the rear end.(*11)
• Tie up the kayak (*12) - proper strapping makes sure it's easy to store in the bag.
• Turn back the bag to slip it over the kayak (*13)
• Position the kayak in the bag
• Fold the seats and store them in the bag (*14) Insert the fins inside the bag (*15) and close it.
• The carrying bag has places to carry the paddles and the pump (*16)
2.4 Storage
• Once dry and clean, the kayak should be stored in a dry, shaded area not affected by significant temperature variations.
p.13