Bunn Single Operating & Service Manual page 21

SERVICE (cont.)
CONTROL THERMOSTAT (cont.)
NOTE - The capillary tube must be clear of any electri-
cal termination and not kinked.
7. Using a #8-32 slotted head screw fasten the control
thermostat to the component bracket.
8. Refer to Fig. 8 when reconnecting the wires.
9. Adjust the control thermostat as required.
FIG. 8 CONTROL THERMOSTAT TERMINALS
BLU to Ready Light
BLK to RED Lead from Liquid Level Switch
BLK to BLK Lead on Contactor Coil
BLK to Ready Light
P842
Page 21
27038 030901