The Buyer shall give Bunn prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, Springfield, Illinois, 62708-3227. If requested by Bunn, the Buyer shall ship the defective equipment prepaid to an authorized Bunn service location.
USER NOTICES (cont.) 00831.0000 00656.0000 20201.5600 ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. WHITE NEUTRAL 120V.A.C. L1 BLACK Requires 2-wire, grounded ser- vice rated 120 volts ac, 20 amp, single phase, 60 Hz.
" water supply line. A tight coil of copper tubing in the water line will facilitate moving the brewer to clean the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply line by this type of device may restrict water flow.
NOTE – The On/Warmer switch must be in the lighted upper position to initiate and complete a brew cycle. COFFEE BREWING 1. Select the desired batch size. 2. Insert a BUNN ® filter into the funnel. 3. Pour the proper amount of fresh coffee into the filter and level the bed of grounds by gently shaking.