Set-Up; Operation; Product Overview - Standard - Bindicator VRF II Series Installation & Operation Manual

VI. SET-UP
WARNING: REMOVE POWER FROM THE UNIT BEFORE INSTALLING, REMOVING OR MAKING
ADJUSTMENTS.

OPERATION

The VRF II Series will begin operating and the green Power LED will be illuminated when power is applied. Once
properly installed, the VRF II Series should be calibrated (refer to Calibration Section) when material is below
the probe. The status of the red Alarm LED is determined by the selected fail-safe mode and whether or not the
probe is in material. Refer to Fail-Safe Operation section. If the unit is calibrated prior to its final installation or if it
is moved from one installation to another, recalibration is required.

PRODUCT OVERVIEW - STANDARD

Figures 3 and 8 show the electronics of the integral and remote versions of the VRF II Series respectively. The
figures show the location of the electrical connections, dip switches SW1, and the Power and Alarm LEDs. The
settings of the VRF II Series are controlled by SW1 as shown in Figure 11.
Figure 11: Switch Functions
VRF180913 Rev. A
13 13
www.bindicator.com