On/Off Switch - Bunn CW-APS Operating & Service Manual

SERVICE (cont.)

ON/OFF SWITCH

FIG. 6 ON/OFF SWITCH
Location:
The ON/OFF switch is located on the left front of
the hood.
Test Procedure:
1. Disconnect the brewer from the power source.
2. Viewing the switch from the back remove the
white wire from the upper terminal and the black
wire from the center terminal.
3. With a voltmeter, check the voltage across the
white wire and the black wire. Connect the brewer
to the power source. The indication must be:
a) 120 volts ac for two wire 120 volt models and
three wire 120/240 volt models.
b) 200 to 240 volts ac for two wire 200 or 240 volt
models.
c) 100 volts ac for two wire 100 volt models.
4. Disconnect the brewer from the power source.
If voltage is present as described, reconnect the white
wire and proceed to #5.
If voltage is not present as described, refer to the
Wiring Diagrams and check the brewer wiring har-
ness.
5. With the black wire removed, remove the white/
red wire from the lower terminal.
6. Check for continuity across the center and lower
terminal with the switch in the "ON" (upper) posi-
tion. Continuity must not be present when the
switch is in the "OFF" (lower) position.
If continuity is present as described, reconnect the
black wire to the center terminal and the white/red wire
to the lower terminal.
P0150.40
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Remove the wires from the switch terminals.
2. Compress the clips inside the hood and gently
push the switch through the opening.
3. Push the new switch into the opening and spread
the clips to hold switch in the hood.
4. Refer to Fig. 7 when reconnecting the wires.
FIG. 7 ON/OFF SWITCH TERMINALS
Page 18
WHI to Terminal Block (White
Insert on 100V, 120V or
120V/240V Models)
Red to Terminal Block (Red Insert
on 200V or 240V Models)
BLK to Terminal Block
(Black Insert)
WHI/RED to Timer P3
P1131
10690 062300