Bunn CW-APS Brewing & Cleaning Instructions

BREWING
®
1. Insert a BUNN filter into the
funnel.
5. Open the flip lid and pour one
pitcher of tap water into the
opening on top of the brewer.
CLEANING
1. Clean and sanitize the funnel.
5. With the sprayhead removed,
insert a deliming spring into
the sprayhead tube until
approximately two inches of
the spring remain visible. Saw
back and forth five or six times
to loosen any lime deposits.
42054.0000A 04/09 ©2009 Bunn-O-Matic Corporation
RELEASED FOR PRODUCTION
CW-APS BREWING & CLEANING INSTRUCTIONS
2. Pour in fresh coffee. Shake
funnel gently to level grounds.
6. When brewing is complete,
discard the grounds and filter.
2. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean the sprayhead panel.
6. Flush the tube by running a
brew cycle using an empty
funnel and Airpot. When the
cycle is completed, replace the
sprayhead.
DIR Num: 42054.0000
3. Slide funnel into the funnel rails
of the brewer.
7. Holding time - discard after
60 minutes.
3. Remove the sprayhead.
7. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean all outer surfaces.
19, May 2015
4. Place an empty Air Pot under
the funnel.
4. Clean mineral deposits and
rinse. Make sure all holes are
open.
42054 040909