Operation; Maintenance - Eastwood 31554 Instructions Manual

OPERATION

DO NOT place heavy components on one extreme corner or edge of the Tear-Down Table. This can cause the balance to shift suddenly,
tipping the Tear-Down Table which can quickly cause severe injury!
• The two Locking Swivel Casters can be locked by pressing down on the Brake Lever. This will prevent the Tear-Down Table from moving. To release brake
feature, lift up on Brake Lever.
Store the Tear-Down Table on a flat, level surface only to prevent possible unattended rolling and property damage.

MAINTENANCE

• Always remove and empty the Fluid Basin after each use to avoid hazardous material spills.
• Periodically clean Drawer of accumulated grease or other debris.
TO REMOVE DRAWER
- Locate the Drawer Glide Latches (FIG 3 & 4) and press DOWN on the right side latch and simultaneously press UP on the left side latch while
pulling the Drawer OUT of the Drawer Box.
TO REPLACE DRAWER
- Slide the Drawer into the Glides making sure the Drawer Glide Latches engage fully and the face of the Drawer closes flush with the face of the
Drawer Box and Table.
• The Tear-Down Table and Box is finished in rugged powder coating which will provide many years of effort free beauty however it is advisable to keep the
finish clean and free from excessive dust and dirt.
• Keep the Tear-Down Table in a clean and dry environment. DO NOT store it in or expose it to a damp or wet environment.
• Occasionally inspect all components for potential damage and proper alignment. Check all hardware for tightness
• DO NOT use if damage is discovered.
6
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com