Eastwood 31554 Instructions Manual page 5

• Attach the "U" shaped Rear Frame Member (previously removed from
the Drain Work Top) to the Drawer Box with four M8 x 15 bolts [H],
Washers [J] and M8 Nuts [K] through the four rear most holes of the
Drawer Box (FIG 5).
• Attach the straight Front Frame Member (previously removed from
the Drain Work Top) to the Drawer Box with two M8 x 15 bolts [H],
Washers [J] and M8 Nuts [K] through the two front holes of the
Drawer Box (FIG 5).
• Place the above assembled Drawer Frame and Box upside down into
the Drain Work Top [A] and re-attach with the four previously removed
M8 Bolts (FIG 6).
• Locate the lowest set of four punched holes in the Legs and align the
punched holes of a Cross Brace [D] and attach with four M8 x 15 bolts
[H], Washers [J] and M8 Nuts [K] (FIG 7). Repeat at other end of
Cross Brace.
• Repeat with the remaining Cross Brace [D].
• Casters [E] & [F] may be added to the Leg Assemblies at this time.
Bolt two Swivel Casters with Brakes [E] to the FRONT Legs (face with
drawer opening) using four M8 x 15 bolts [H], Washers [J] and M8
Nuts [K] (FIG 8).
• Attach two Swivel Casters [F] to the REAR Legs with four M8 x 15
bolts [H], Washers [J] and M8 Nuts [K] (FIG 9).
Due to the size and considerable weight of the
Tear-Down Table it is necessary to obtain the assis-
tance of a capable helper during the following step:
• With your helper lifting the opposite side, carefully raise and rotate the
Tear-Down Table so that it may be set down on the Casters.
• Slide the plastic Fluid Basin [G] into the Guides under the Drain located
at the left side of the Drain Work Top [A]. Push in until it contacts the
stop bolts in the Guides.
• Slide the previously removed Drawer into the Drawer Box making sure
the Drawer Glide Latches engage fully and the face of the Drawer
closes flush with the face of the Drawer Box.
• Your Eastwood Tear-Down Table is now ready for use.
To order parts and supplies: 800.345.1178 >> eastwood.com
 """"
FIG. 5
C
Front
Frame
Member
H, J, K
FIG. 6
A
   " " " "
FIG. 7
   " " " "
D
FIG. 8
E
H, J, K
Drawer Box
"U"-Shape
Frame
Member
M8 Bolts
Assembled
Drawer Box
and Frame
B
D
H, J, K
FIG. 9
F
H, J, K
5