Error Messages - Brother HL-1660E User Manual

Error Messages

Error Message
31 PRINT OVERRUN
32 BUFFER ERROR
34 MEMORY FULL
40 LINE ERROR
41 PRINT CHECK
Meaning
Print overrun
Input buffer overflow
Work memory overflow
Error in the communications
circuit
Error in communication with
the engine controller
CHAPTER 7 TROUBLESHOOTING
Action
Press the CONTINUE switch
to start printing the next page.
Data which overran the print
area on the page cannot be
printed. Check your page
protection setting with the
MODE switch. Setting page
protection to the correct size
could solve this problem. If
printing at 600 dpi, you may
need to add optional SIMM
memory. See page 5-7.
Press the CONTINUE switch
to resume printing. Data lost
in overflow cannot be printed.
See page 4-46.
Press the CONTINUE switch
to resume printing. If the same
error should occur after you
press the CONTINUE switch,
turn off the printer. Wait a few
seconds, then turn it on again.
Reduce the input buffer size.
See page 4-46. Turn off
"KEEP PCL." Add SIMM
memory with power off.
Download font and the fonts
saved in the HDD card might
cause the error, for it occupies
the same work area as the
RAM. Memory expansion is
recommended in that case.
See page 5-7.
When the serial interface is
used, check the
communications parameters
such as baud rate, code type,
parity, and handshake
protocols. When the parallel
interface is used, check the
interface cable connection.
Turn off the printer. Wait a
few seconds, then turn it on
again.
7–3