Print Density; Input Buffer - Brother HL-1660E User Manual

USER'S GUIDE
4–46

PRINT DENSITY

You can increase or decrease the print density with the
this mode menu as follows:
Display Message
:

INPUT BUFFER

You can increase or decrease the capacity of the input buffer with the
or switch in this mode menu. A larger capacity allows the printer to
receive data from the computer faster.
Display Message
:
:
After you change the input buffer capacity (make sure you press SET
switch), be sure to turn off the printer and then turn it on again. The
setting takes effect the next time you turn on the printer.
Notes
The set capacity is not changed even if the emulation mode is changed.
The actual capacity of the input buffer varies according to the installed
RAM. If the RAM capacity is small, the input buffer capacity may not
be increased.
When you select duplex printing, it requires more memory to run
duplex printing. If you set a large input buffer and the remaining
memory is not enough to run duplex printing, the print speed may
decrease in duplex printing, the 600dpi resolution may decrease to
300dpi, or the printer may automatically change duplex printing to
simplex printing. In such a case, you need to install optional SIMM
memory or set a smaller input buffer size in this mode.
Print Density
The more black squares, the darker the
print density. The black squares indicate
the density level.
The density can be set to 15 levels.
(Factory setting =
Input Buffer
The more squares, the larger the capacity
of the input buffer. The squares indicate
the level of the capacity but not the size in
Mbytes.
The capacity can be set 15 levels.
(Factory setting =
or switch in
)
)