Filter Installation; Cleaning & Disinfecting The Ash Vacuum; Storage - Craftsman 125.16819 Operator's Manual

Maintenance (Continued)

Filter Installation

1
1. Install the cartridge fi lter so that it is
fl ush with the vacuum power head
lid. Make sure that the cartridge fi lter
is pushed in until it stops against the
power head and presses the switch
down. (Fig. 1 & 2) Ensure that the
Cleaning and Disinfecting the
Ash Vacuum
To keep your ash vacuum looking
its best, clean the outside with a
dampened cloth, then dry with a clean
towel.
To clean the inside of the collection
tank:
1. Empty debris out.
2. Wash collection tank thoroughly with
warm water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
the collection tank should be disinfected.
To disinfect the collection tank:
1. Pour 1 gallon (3.7 L) of water and 1
teaspoon chlorine bleach into the
collection tank.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside
surfaces of the collection tank.
3. Empty collection tank after 20
minutes. Rinse with water until
bleach smell is gone. Allow collection
tank to dry completely before placing
the power head back onto the
collection tank.
2 3
cartridge fi lter is pressed against the
switch.
2. Place fi lter cage on the top of
cartridge fi lter and lock into place by
turning the cage clockwise. Do not
overtighten. (Fig. 3 & 4)

Storage

Before storing your ash vacuum, the
collection tank should be emptied
and cleaned. The hose, cord and
accessories should be stored as
illustrated above so they can be readily
available when needed.
Store vac indoors.
9
4