During Operation; After Operation; Troubleshooting - Honda HHB36AXB Owner's Manual

6 | English

During operation

Always hold the garden tool firmly in your hand.
Walk slowly forwards as you work, observe the nozzle
outlet at all times.
To reduce the risk of injury, operate the unit only with a
properly mounted blower tube.
The flat nozzle produces a broad and powerful airstream
at ground level. It can be aimed and controlled very
accurately.
This garden tool is design to be used by one person only.
Do not allow other persons in the work area.
Do not direct the airflow towards bystanders or animals
since the airflow can blow small objects at great speeds.

Troubleshooting

Problem
Machine does not start
after turning off
Machine runs
intermittently
Machine fails to operate
Machine does not blow
Excessive vibrations/
noise
Run time per battery
charge too low
Tube cannot be mounted
on the machine
If you are unable to resolve the problem using the troubleshooting guide then please contact your dealer in the first
instance.
Possible Cause
The switch was not turned off
properly before the battery adapter
was inserted
On/Off switch defective
Low battery capacity
The machine is overheated
Battery discharged
Battery too hot/cold
Machine defective
Battery carrier defective
Battery adapter not fully inserted
Garden tool is too hot
Trigger engaged when battery fitted Release trigger and reapply.
Tube obstructed
Battery adapter contacts on
machine damaged/ obstructed
Tube obstructed
Inlet guard obstructed
Machine defective
Battery dead or defective
Incorrect assembly
Blower tube is damaged/defective
This product is fitted with thermal protection for
safety – if the product overheats the power output will
be automatically reduced to prevent damage to the tool.
If the overheating still occurs, the product will switch
off and will not start again until a safe temperature is
reached. Refer to the battery and battery carrier manual
for troubleshooting.
To reduce the risk of accidents, take a break in good time
to avoid tiredness or exhaustion.
If there is a noticeable change in running behaviour
(e. g. higher vibration), stop work and rectify the cause of
the problem – refer to troubleshooting

After operation

Always make sure the product is turned off and remove
the battery adapter from the garden tool.
Corrective Action
Turn the switch off, remove the battery adapter from
the product for 5 seconds. Re-insert the battery
adapter into the product.
Have the power tool repaired by an authorised
service dealer.
Ensure battery is fully charged before use.
Allow tool to cool and try again.
Recharge battery.
Allow to cool/warm.
Contact authorised service dealer.
Contact authorised service dealer. See battery
carrier manual.
Ensure battery adapter is inserted correctly.
Allow tool to cool and try again.
Switch off the machine, remove battery and remove
material.
Clean contacts/Contact authorised service dealer.
Remove battery adapter Clear tube.
Remove battery adapter Clear inlet guard.
Contact authorised service dealer.
Replace the battery.
See "assembly".
Replace the tube.