Mitsubishi MJ-E16V-S1 Service Manual page 8

[OFF Timer Operation]
The OFF timer can be set for each 2, 4, 8 hours.
Set the timer when the power is switched on.
4
1
Open the louvre manually
2
Switch the power on
3
Select operating mode
Select desired operating mode
4
Set operating time
No Display
(Low mode)
➝The OFF Timer is set
¡ OFF Timer lamp indicates remaining time
¡ Power automatically turns off at set time
If drying inside is set to activate automatically,
drying inside activates.
To cancel
<When you want to turn the unit off>
Press the Power button.
(Power off)
<When you want to disable the Timer
OFF mode, and continue operation>
Hold down the button
until the OFF Timer lamp
goes out. The unit returns
to Low mode.
∞ Empty the water tank before operating. The unit
stops and the Tank full lamp lights if the tank
becomes full during operation.
∞ The OFF timer cannot be set while drying inside
is operating.
8
3 2
¡ One press - 2 is
displayed
¡ Each consecutive
press displays the
following setting
(2, 4, 8)
Press
Press
Press
[Removing Water from the Tank]
The unit automatically shuts down and lights the Tank
full lamp when the tank (approximately 4L) is full.
Empty the tank.
1
Remove the water tank.
Open the front door.
<Hold the tank this
way>
2
Remove the tank lid, and empty.
Tank lid
3
Reattach the tank lid and replace
the water tank.
¡ If the lid is not properly closed, you may have
problems removing the tank.
¡ If the tank is not installed correctly, the tank full
light will come on, and the unit will not operate.
Do not remove or dismantle the floating element in
the tank. If it is removed, the unit cannot detect
when the tank is full, and this could result in
leakage.
Grasp handle and
slide out.
Floating element
Do not remove or
dismantle the float.
Pour the
water out
as shown.
Confirm that the lid is
securely attached to the
water tank, and push the
tank in. Close the front
door.