Mitsubishi MJ-E16V-S1 Service Manual page 28

5. To remove the fan assembly
Step 1) Remove the water tank, front panel, air
filter assembly, front casing assembly,
main board, and rear casing following
the steps for sections 1 to 4 above.
Step 2) Remove the condenser and
connectors (9) from the power board.
Step 3) Remove the lead wires from both sides
of the fan guide casing.
Step 4 Remove the power board box
assembly.
Step 5) Detach the catches (one on each side)
that interlock the fan assembly and the
drain pan by leaning the top of the fan
assembly toward the heat exchanger
and pulling upward. Remove the fan
assembly.
Fan
Repairable
Float switch
parts
Heat exchanger (radiator, refrigerator)
[To remove the fan motor]
Step 1) Remove the fan locknut and fan.
Step 2) Remove the tape securing the fan
motor lead wire, and separate the lead
wire from the fan guide casing.
Step 3) Remove the motor holding plate and
setscrews (3).
Step 4) Remove the holding plate, fan motor,
and fan motor cushion.
[To remove the float switch]
Remove the float switch attached to the drain
pan.
Picture 17
6. To remove the drain pan assembly
Step 1) Remove the water tank, front panel,
front casing assembly, rear panel, and
fan assembly following the steps for
sections 1 to 5 above.
Step 2) Detach the catches interlocking the
drain pan and the base, and remove
the base while lifting the right side of
the heat exchanger.
Repairable
Compressor
parts
28
(Pic. 13)
(Pics. 14, 15)
Fan motor
(Pic. 15)
(Pic. 16)
(Pic. 16)
(Pic. 17)
Switch
(Pics. 18, 19)
Picture 13
Valve
Picture 14
Catch
Picture 15
Picture 16
Picture 18
Catches for interlocking
the drain pan and base
Picture 19
Heat
exchanger
Box
Fan assembly
Fan
Net
Motor holding
plate setscrew
Base