Mitsubishi MJ-E16V-S1 Service Manual page 27

[To remove the control board]
Step 1) Pull the front casing/switch operation
part toward the outside, release the
catch (protrusion) on the switch button
on the main board cover side, and
remove the main board cover
assembly.
Step 2) Release the main board catches (4
below, 1 on the right), and remove the
main board.
Catch
Picture 7
4. Removing the rear casing
Step 1) Remove the water tank, front panel,
and front casing assembly following
the steps for sections 1 to 3 above.
Step 2) Remove the rear casing setscrews (6).
Step 3) Push the rear casing downward, and
pull outward to detach the catches on
the bottom. Lift the rear casing and
raise the handle. Detach the catches
that prevent the handle from coming
loose, and remove the handle.
Step 4) Pull the top part of the rear casing
outward, and detach the catches (one
on each side) that interlock the screw
stop boss and the guide on the side of
the fan assembly.
Step 5) Lift the rear casing upward, and
remove from under the louvre.
Step 6) Remove the louvre net.
Fan Temperature/humidity sensor
Repairable
Solenoid valve
parts
Thermal over current switch
Picture 11
Catches (one on each side)
(Pic. 6)
(Pics. 7, 8)
(Pic. 9)
(Pic. 10)
(Pic. 10)
(Pics. 11, 12)
Float switch
Picture 6
Picture 8
Picture 9
Rear panel
setscrew
Picture 10
Picture 12
Handle
Louvre
Sensor
27