Brother HL HL-3070CW User Manual page 154

Error messages (continued)
Error message
No Toner
No Waste Toner
Out of Memory
Print Unable 1A
Short Paper
Size Mismatch
Small Paper
Toner Error
Unusable Device
(HL-3070CW only)
Error messages in Colour Correction
Call service message
Calibrate
<Scrolling message>
Calibration failed.
See Troubleshooting
chapter in User's
guide.
Registration
<Scrolling message>
Registration
failed. See
Troubleshooting
chapter in User's
guide.
Action
Re-install the toner cartridge that is indicated on the LCD. (See Toner cartridges
on page 104)
Re-install the drum unit that is indicated on the LCD. (See Drum units on page 112)
Re-install the Waste Toner Box. (See Waste toner box on page 122.)
If the LCD shows this error message when you print the secure data, Press Cancel and
delete the previously stored data.
Except in the case of printing secure data, add more memory. (See Installing extra memory
on page 100.)
Turn the power switch off and fully open the top cover. Leave the printer off and open for 30
minutes to remove any condensation from inside the machine, then close the top cover and
turn it on again. If this does not clear the error, call your dealer or a Brother Customer
Service.
Open the back cover (back output tray) to let the printed paper out on the back out put tray.
Remove the printed pages and then press Go.
Put the same size paper in the paper tray that is selected in the printer driver, and then press
Go, or select the size of paper you set in the Tray1 Size setting from the control panel.
Open the back cover (back output tray) to let the printed paper out on the back out put tray
and then press Go.
Pull out all the drum unit and toner cartridge assemblies. Take out the toner cartridge and
put it back into the printer again.
Remove the USB flash memory drive from the USB Direct Interface.
Action
Turn off the printer. Wait a few seconds, then turn it on again.
Identify the colour causing the problem and put in a new drum unit. (See Replacing
the drum units on page 113.)
To identify the colour of the drum unit, visit us at http://solutions.brother.com/ to view
our FAQs and troubleshooting tips.
Put in a new belt unit. (See Replacing the belt unit on page 118.)
Put in a waste toner box. (See Replacing the waste toner box on page 123.)
If the problem continues, call your dealer or Brother Customer Service.
Turn off the printer. Wait a few seconds, then turn it on again.
Put in a new belt unit. (See Replacing the belt unit on page 118.)
If the problem continues, call your dealer or Brother Customer Service.
Troubleshooting
6
144