Installation Of System - auna DigiPlug UP Manual

INSTALLATION OF SYSTEM

1. Interrupt the Main Power supply for your house/apartment completely
(consult professional Electricity Engineer & assure the AC socket with
NO power supply during connection)
2. Strip the wire ends of the supply line about 5-10 mm
3. Fasten the wire ends in the appropriate terminals and assure it is
enclosed by insulation type completely at the connection points.
Battery Replacement for Remote
1. Remove the battery holder from the battery compartment
2. Replace the button cell battery (type : CR2025) with correct polarity in
the battery holder
3. Re-inset the battery holder in the battery compartment.
LISTENING TO FM
Manual tuning
1 Switch on the device with the on/off button (1a).
2 Press the Tuning up/down button (8) on the remote control to tune to
the desired station.
3 Adjust the volume with the up/down button (1c & 1d) to the desired
volume level.
Automatic Tuning
1 Press the SCAN button (1b) or (8c) on the remote control. The unit will
start scanning in an up or down direction until the radio station is
received.
2 Adjust the volume to the desired level with the up/down button (1c &
1d).
EN
17