Table of Contents
Advertisement
The roller will come to an immediate stop as soon as the
drive lever (1) is released.
If the operator bumps against the crush guard (3) when
moving in reverse, the machine comes to a stop.
Through swinging out the drive lever (1) forward in the
direction of travel, the crush guard is again lifted up.
Always move the vibration adjustment lever (2) to the
stop, otherwise increased abrasion occurs on the V-belt.
At obstructions (walls, pits, etc.), ensure that no one can
be caught between the machine and the obstruction; or
ensure that the machine does not slip into the pit.
Only run machine within reach of the manual guidance rod.
Shutting down
Bring the gas lever (2) into idle position.
Move vibration lever (1) to position ( ).
Pull the arrest lever all the way back (horizontal) until it
locks in place on slopes the roller must additionally be
secured against rolling off via wedges!
Close the water cock (1).
1
3
1
1
2
1
2
15
Advertisement
Table of Contents
