Motorola AAM19X501 User Manual

m
AAM19X501
Desktop Charger
User Guide
*MN004240A01*
MN004240A01-AB
Printed in
Important Safety Instructions
This document contains important safety and
operating instructions. Please read these
instructions carefully and save them for future
reference.
Before using the battery charger, read all the
instructions and cautionary markings on the
charger, battery, and radio using the battery.
1.To reduce risk of injury, charge
! !
only the rechargeable Motorola
Solutions Authorized Batteries.
W A R N I N G
Other batteries may explode,
causing personal injury and
damage.
1
2. Use of accessories not recommended by
Motorola Solutions may result in risk of
fire, electric shock, or injury.
3. To reduce risk of damage to the power
supply electric plugs and cords, pull the
plug rather than the cord when
disconnecting from the AC outlet or the
charger.
4. An extension cord should not be used
unless absolutely necessary. Use of an
improper extension cord could result in
risk of fire and electric shock. If an
extension cord must be used, make sure
that the cord size is 18 AWG for lengths of
up to 6.5 feet (2.0 m), and 16 AWG for
lengths up to 9.8 feet (3.0 m).
5. To reduce risk of fire, electric shock, or
injury, do not operate the charger if it has
been broken or damaged in any way.
6. Do not disassemble the charger. It is not
repairable and replacement parts are not
available. Disassembly of the charger may
result in risk of electric shock or fire.
7. To reduce risk of electric shock, unplug the
charger power supply from the AC outlet
before attempting any maintenance or
cleaning.
8. This is a Class A product. In a domestic
environment, this product may cause radio
interference in which case the user may
be required to take adequate measures.
2
Operational Safety Guidelines
• This equipment is not suitable for outdoor
use. Use only in dry locations and
conditions.
• Connect the power cord only to an
appropriately fused and wired AC outlet
with the correct voltage, as specified on the
product.
• The AC outlet to which the power supply is
connected should be close and easily
accessible.
• Make sure the power supply cord to the
charger is located where it will not be
stepped on, tripped over, or subjected to
water, damage, or stress.
• Disconnect from line voltage by removing
the power cord from the AC outlet.
• Turn the radio off when charging the
battery.
• Use only Motorola Solutions authorized
supply. Do not connect an improper AC
adapter.
• The charger and/or AC Adapter will
generate a moderate amount of heat
during the charging process. This is a
normal condition.
• The charger is designed for charging only
and is not designed for operation (transmit
or receive) of the radio.
• If the LED indicator of the radio blinks red,
reinsert the radio. If the LED continues
blinking red, the battery is faulty. Replace a
new battery for the radio.
3