Table Of Contents 2 Installation - HAMPTON BAY HB2581-34 Use And Care Manual

Installation
1
Attaching the mounting bracket

Thread two hex nuts (FF) onto the nipple
(AA) to the midpoint.

Thread the nipple (AA) in through the
center hole of the mounting bracket (CC)
approximately 1/3 of the way. Do not
tighten the hex nuts (FF).

Pull the supply wires out from the outlet
box.

Attach the mounting bracket (CC) to the
outlet box by feeding the mounting screws
(BB) through the slots of the mounting
bracket (CC) and tightening them into the
mounting holes of the outlet box.
2
Aligning the canopy

Thread the screw collar loop (MM) 8 to 9
turns onto the bottom end of the nipple
(AA).

Tighten the bottom hex nut (FF) against
screw collar loop (MM).

Place the canopy (B) over the outlet box.

Turn the screw collar loop (MM) until the
midpoint of the outer threads of the screw
collar loop (MM) aligns with the bottom
surface of the canopy (B).

Remove the canopy (B) and tighten the top
hex nut (FF) against the mounting bracket
(CC).
CC
BB
B
5
Please contact 1-855-HD-HAMPTON for further assistance.
FF
MM
HAMPTONBAY.COM
AA
MM