Eyelet Stitching - Brother CS-8060 Operation Manual

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4,
15/64 and 3/16 inch).
Stitch Name
Pattern
Sewing eyelets, for example,
Eyelet stitch
on belts
1 Attach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 35).
2 Select stitch .
• For details, refer to "Selecting stitching"
(page 58).
3 Adjust the stitch width to select the desired
eyelet size.
6 mm
7 mm
(15/64 inch)
(1/4 inch)
• For details, refer to "Adjusting the Stitch
Width and Length" (page 51).
4 Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
Application
5 mm
(3/16 inch)
Stitch Width Stitch Length
[mm (inch.)] [mm (inch.)]
Auto Manual Auto
7.0, 6.0 or
7.0 5.0 (1/4,
–
(1/4) 15/64 or
3/16)
5 Start sewing.
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
Use the eyelet punch to cut a hole in the
6
center of the eyelet.
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
● If thin thread is used, the stitching may be
coarse. If this occurs, sew the eyelet twice
before remove the fabric, one on top of the
other.
Presser
Foot
Manual
– N

Eyelet Stitching

87