Brother CS-8060 Operation Manual page 111

Symptom
The feed dogs are lowered.
The stitch is too fine.
The presser foot that is used is not
The fabric does
appropriate for the type of stitch that
not feed.
you wish to sew.
The thread is tangled, for example,
in the shuttle.
The sewing lamp
does not come on. The sewing lamp is damaged.
Probable Cause Remedy
Slide the drop feed lever to the left.
Lengthen the stitch length.
Attach the presser foot that is appro-
priate for the type of stitch that you
wish to sew.
Remove the tangle thread. If the
thread is tangled in the shuttle, clean
the shuttle.
Contact your retailer or the nearest
authorized service center.
Reference
page 83
page 52
page 96
page 100
–
Troubleshooting 105