Brother CS-8060 Operation Manual page 40

GETTING READY ———————————————————————————————————————————————————
Lower the needle-changing tool.
4
The needle can be removed from the needle
bar.
Insert the new needle into the hole in the
5
needle-changing tool.
Insert the needle with the flat side of the needle
toward the rear of the machine.
Lift up the needle-changing tool so that the
6
fork hooks onto the needle clamp screw.
34
Insert the needle until it touches the needle
7
stopper, and then use the screwdriver to
tighten the needle clamp screw.
The needle is installed.
8 Lower the needle-changing tool off of the
needle.