Automatic TriPlus Greasing System This vehicle is equipped with a Groeneveld Automatic TriPlus Greasing System. Featuring key The TriPlus Greasing System will automatically and unconditionally grease all connected grease points on a timely basis (cycle) with the correct quantity of grease.
TriPlus system is of utmost importance. The use of grease with a maximum of 5% molybdenum disulphide (MoS2) is permitted. Groeneveld recommends the use of its GreenLube grease. Consult your local Groeneveld dealer prior to change of grease (specifications) or any other inquiries you may have. Regularly checks of the greasing system Check the following points of the TriPlus greasing system: The grease level in the reservoir of the pump unit (refill on time);...
Page 4
The signal lamp The signal lamp is mounted in the field of vision of the driver and out of direct sunlight, because of the visibility of the signals. The lamp shows the status of the greasing system and malfunction reports by means of flashing codes. In the table below, an overview of normal signals is given.
Page 5
The signal lamp error flash codes The signal lamp indicates the fault codes by flashing. Dozens are shown by long pulses (0,5 seconds). Units are shown by short pulses (0,15 seconds). Examples Pulses Error code long, short, short, short, short long, long, short Error code Malfunction...
Page 6
Error code Malfunction Open load block switch C High temperature PCB exceeded Low temperature PCB exceeded At any malfunctions with the automatic greasing system, please contact your Groeneveld dealer as soon as possible. F211955R00...
Page 8
Groeneveld Transport Efficiency B.V., Stephensonweg 12, 4207 HB Gorinchem, P.O. Box 777, 4200 AT Gorinchem, The Netherlands, Ph : +31 183 641 400, F : +31 183 624 474, http://www.groeneveld-group.com...
Need help?
Do you have a question about the TriPlus Truck-3 and is the answer not in the manual?
Questions and answers