Assembling The Saw - Dimas WS 463 Operator's Manual

Operator's Manual WS 463

Assembling the saw

1. Fit the saw body in the saw carriage by lifting the saw
body into position. When the saw is lifted into position,
the locking handle moves up into an intermediate
position. In this position the saw remains in the saw
carriage without it needing to be held. However, it is
not sufficiently secured to begin cutting.
Remark
With a vertical cut it is usually simpler to
assemble the saw in the saw carriage with the
handle upwards on the rail.
2. To secure the saw, lift the locking handle towards the
saw until the handle locks in the upright position.
WARNING!
To cut without the saw securely assembled
in the saw carriage and rail is associated
with mortal danger.
3. When the saw unit is mounted in the saw carriage, the
hydraulic hoses should be fitted. There are two types
of hydraulic hoses for the saw:
The four thin hoses control the feed motors, i.e. the
saw's travel feed on the rail and the feed - removal of
the blade. The two thick hoses drive the blade.
The couplings should be wiped clean to reduce the risk
of leakage before the hoses are fitted. Both the thin
and thick hoses are locked by turning the outer sleeve
on the female coupling so that the groove in the sleeve
moves away from the ball.
4. Connect the incoming water hose and the hydraulic
hoses to a hydraulic unit.
WARNING!
This machine is only intended for use
together with a DIMAS PP 345 and DIMAS
RC 348. All other use is forbidden.
English - 11