Replace The Lamp; Troubleshooting - Tecla RS0905H1 User Manual

• Do not allow such substances to come into contact the appliance
parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them in a cool place, well
covered.
• Switch the appliance off and remove the plug from the mains, or
switch off the circuit breaker or fuse.
• Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
• Accumulation of dust at the condenser increases energy
consumption. For this reason carefully clean the condenserat the
back of the appliance once a year with a soft brush or a vacuum
cleaner
1
• After everything is dry place appliance back into service.

Replace the lamp

CAUTION!
Before replacing the lamp, shall disconnect the appliance from mains
power supply.
Lamp specification is listed in rating label.
Follow below process to replace the lamp:
1. Set the temperature regulation knob at number "0" to switch off
the appliance.
2. Unplug the appliance to make sure the appliance is disconnected
from main power supply.
3. Remove the screw of the lamp cover.
4. Remove the lamp cover out by a flat screw driver.
5. Unscrew the lamp by two fingers.

TROUBLESHOOTING

CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not
in this manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant circulation).
Problem Possible cause
Temperature regulation knob is set at number "0".
Power plug is not plugged in or is loose
Appliance does not
work
Fuse has blown or is defective
Socket is defective
Temperature is not properly adjusted.
Door was open for an extended period.
The food is too warm.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
The appliance is near a heat source.
Appliance cools too
Temperature is set too cold.
much
Appliance is not level.
The appliance is touching the wall or other
objects.
Unusual noises
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
If the malfunction shows again, contact the Service Center.
6. Fit new lamp according to the opposite direction, then replace the
lamp cover.
7. Plug in the appliance and regulate the knob to right position.
Defrosting
The evaporator, however, will become progressively covered with
frost. This should be removed. Never use sharp metal tools to scrape
off frost from the evaporator as you could damage it.
However, when the ice becomes very thick on the evaporator,
complete defrosting should be carried out as follows:
• pull out the plug from the socket;
• remove all stored food, wrap it in several layers of newspaper and
put it in a cool place;
• keep the door open, and placing a basin underneath the
appliance to collect the defrost water;
• when defrosting is completed, dry the interior thoroughly replace
the plug in the power socket to run the appliance again.
Solution
Set the knob at other number to switch on the appliance.
Insert power plug.
Check fuse, replace if necessary.
Socket malfunctions are to be corrected by an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder setting
temporarily.
Please look in the installation location section.
Turn the temperature regulation knob to a warmer setting
temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out of the way.
13
ENG