Q & A; Setting Up The Printer Hardware; Setting Up The Printer For Windows - Brother HL-720 User Manual

USER'S GUIDE
Q & A

Setting Up the Printer Hardware

Question
The printer does not work. All
lamps are off.
The printer does not print.

Setting Up the Printer for Windows

Question
I cannot print from my
application software.
Sometimes I get a Print Overrun
error when printing certain
documents from Windows.
CHAPTER 6 –8
This section contains questions and answers for using your printer. If you
have encountered a problem, find the question relating to your problem and
take the steps recommended to correct the problem.
Recommendation
The printer may be in sleep mode. Press the panel
switch to wake up the printer. Check to see if the
printer is plugged into a live power source and the
power switch is on.
Check the following:
The printer is turned on.
All of the protective parts have been removed.
The toner cartridge and drum unit are installed
properly.
The interface cable is securely connected between
the printer and computer.
Check to see if the Alarm lamp is blinking. If the
lamp is blinking, refer to the Operator Call section
of this manual.
Check to see if the Ready lamp is blinking. If the
lamp is blinking fast, the printer might be cooling
down to lower the printers internal temperature.
Open the top cover of the printer to lower the
temperature.
Recommendation
Make sure the supplied Windows printer driver is
installed and selected with your application
software.
If you use the serial interface, make sure that the
serial slide switch of the serial interface is in the
correct position and the interface settings are
correctly set up with the DIP switches. (For HL-
730/730Plus series Only)
If you are using the supplied Windows driver, turn
error recovery operation on in the Setup dialog box
and try again.
Reduce the print resolution or reduce the
complexity of your document and try again.
Expand the printer memory by installing one of the
optional memory boards.