Pat Testing; General Safety Requirements; Maintenance - Prem-I-Air EH0522 Instructions Manual

When used in an office environment, this product must be safety-tested
yearly by a qualified electrician (PAT Tested) in order to comply with the
Electricity at Work Regulations.
If hired out, it must be PAT tested prior to each hire.
We recommend that it is PAT tested regularly when used in a domestic
environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified electrician at
least once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the
wiring must be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is
mandatory for new buildings).
At time of going to press, the average cost of electricity is 12p per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill. At this cost, the fan will cost 29p per day to run on the "low
speed" setting, 31p per day on the "medium speed" setting or 37p per
day to run on the "high speed" setting.
Before cleaning, turn the appliance off, and disconnect from the mains
supply. The appliance may then be cleaned using a damp cloth with a
drop of washing-up liquid to remove any dust or dirt from the case. Do no
use stronger detergents or solvents as these may damage the paint
finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is d amaged, it must be replaced by the manufacturer or
Earth
(Green
Yellow)
Live
Neutral
(Brown)
(Blue)
(over the outer sheath of the cable) and it fully tightened.
• If the plug is fitted with a 13 A fuse, replace it by a 3 A fuse.

PAT TESTING

OPERATING COSTS

MAINTENANCE

and authorised service centre.
Fuse
(3A)
If the mains plug needs to be replaced, proceed as
follows:
• Connect the brown wire to the terminal labelled "L".
• Connect the blue wire to the terminal labelled "N".
• Connect the green/yellow wire to the terminal
labelled with the earth symbol or "E".
• Make sure that the cord-grip is positioned correctly
Page 3