Configuring The Brother Print Server (Remote Printer Mode) Using Pconsole And Brconfig - Brother HL-5170DN Network User's Manual

Service is the name of the service assigned by NetWare print
server name (where the default services are
BRN_xxxxxx_P1 for the Brother printer, where xxxxxx is
the last six digits of the Ethernet address (MAC address)).
You can also enter the TREE and CONTEXT name using
your web browser, by connecting to the Brother print server
using the TCP/IP protocol and selecting the NetWare
protocol configuration.
22
Use the BRCONFIG command or TELNET command: SET
NETWARE RESCAN to force the print server to rescan for file
servers, or power cycle the printer.
The same service assigned by NetWare print server cannot
be used for both queue server mode and remote printer
mode. If you want to enable remote printer capabilities on a
service other than the default NetWare service, you must
define new services that are enabled for NetWare and for the
desired port. Refer to Appendix in this manual for information
on how to do this.
Configuring the Brother Print Server
(Remote Printer Mode) Using PCONSOLE and
BRCONFIG
1
Make sure that the PSERVER NLM (NetWare Loadable
Module) is loaded on your file server.
2
Log into the file server from your PC workstation as ADMIN if you
are using NetWare 4.1x (if you want NDS support, do not login
under bindery mode). If you are using NetWare 2.xx or 3.xx,
login as SUPERVISOR.
3
Run the PCONSOLE utility from your PC workstation.
4
If you are creating a new print queue, select Print Queue
Information (NetWare 3.xx) or Print Queues (NetWare 4.1x)
from the Available Options menu.
NOVELL NETWARE PRINTING 6 - 18