Using Your Appliance; Cleaning And Maintenance - Akai A60010 Instruction Manual

USING YOUR APPLIANCE

POWERING ON:
The radio can be powered with batteries
or using the adaptor.
Turn the Power/Volume dial to the 'ON'
position to turn the radio on.
USING YOUR APPLIANCE:
1. Place the Vintage 4 Band Radio
on a flat level surface, taking care
to leave about 10cm of ventilation
space all around the unit.
2. Connect the unit to the power
supply.
3. Turn the Power/Volume dial to the
right to turn the unit on.
4. Press the FM/MW/SW/LW buttons
to choose your preferred band.
5. Choose your preferred station
using the tuning control dial.
6. Use the Volume dial to adjust the
output volume.
7. Use the Tone dial to adjust the
output pitch.
8. Turn the Power/Volume dial to the
left while the unit is in operation to
turn it off.
BATTERIES:
To install the batteries, open the battery
compartment located at the back of
the unit and place 6 x 1.5V /C batteries,
taking care not to reverse the poles.
Once the batteries have been installed,
close the battery compartment.
POWER ADAPTOR:
To charge the unit using the power
adaptor, insert one end of the adaptor
into the DC jack at the back of the unit,
plug the other end in at the mains and
turn the power outlet on.
CLEANING & MAINTENANCE:
1. Always disconnect the unit from
the power supply before cleaning.
2. Clean the unit with a soft, damp,
lint free cloth.
3. Do not use abrasives or harsh
cleaners.
WARNING:
DO NOT IMMERSE ANY ELECTRICAL
PART OF THE APPLIANCE IN WATER
SUCH AS MOTOR UNITS OR PLUGS.
PLEASE SEE CLEANING SECTION FOR
FURTHER INSTRUCTIONS.
7