Section 5 - Operation; Operation; Power Washer Location; Checklist Before Starting Engine - Generac Power Systems OneWASH Operator's Manual

Operation

Section 5
5.1 — O
PERATION
If you have any problems operating your power washer,
please call Generac customer service at
1-888-436-3722.
5.2 — P W
OWER ASHER
5.2.1 — Clearances and Air Movement
Running engine gives off carbon monoxide,
an odorless, colorless, poisonous gas.
Breathing carbon monoxide can cause head-
ache, fatigue, dizziness, vomiting, confusion,
seizures, nausea, fainting or death. For more
information, reference the CO warnings in the
"Safety" section.
Place power washer outdoors in an area that will not
accumulate deadly exhaust gas. NEVER place power
washer where exhaust gas could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows,
doors, ventilation intakes, or other openings that can
allow exhaust gas to collect in a confined area. Prevailing
winds and air currents should be taken into consideration
when positioning power washer (Figure 5-1).
• Operate power washer ONLY outdoors.
• Keep exhaust gas from entering a confined area
through windows, doors, ventilation intakes, or other
openings.
• NEVER start or run engine indoors, in a vehicle or in
an enclosed area, EVEN if windows and doors are
open.
Exhaust heat/gases can ignite combus-
tibles, structures or damage fuel tank
causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of
power washer including overhead.
OneWASH™ Power Washer
L
OCATION
Figure 5-1. Building Clearances
5.3 — C
HECKLIST
E
NGINE
1. Be sure to read and understand the "Safety" section
and "Operation" section before using power washer.
2. Check that the oil is at the full mark on the dipstick,
and that fuel has been added to the fuel tank.
3. Review the unit's assembly and ensure fitting are
properly secured and make sure there are no kinks,
cuts, or damage to high pressure hose.
4. Provide a proper water supply at an adequate flow,
clear screens of debris, and confirm that the system
is purged of air.
5. Confirm unit is secure on level ground and surround-
ing work area is clear.
5.4 — H S
OW TO TART
W
ASHER
DO NOT run the pump without the water supply con-
nected and turned on. Damage to equipment result-
ing from failure to follow this instruction will void
warranty.
5 Foot Minimum
B S
EFORE TARTING
Y P
OUR OWER
NOTE:
19