Brother HL-1060 Series User Manual page 53

Follow these steps to replace the drum unit:
1. Turn off the power switch.
2. Open the top cover and remove the old drum unit.
Fig. 5-10 Removing the Drum Unit
Warning
After you have just used the printer, some internal parts of the printer
are extremely hot. When you open the top cover of the printer, never
touch the shaded parts shown in the following illustration.
3. Remove the toner cartridge from the drum unit and keep it in a safe
place. For more information, see
CARTRIDGE" in this chapter.
Note
Discard the used drum unit according to local regulations. If you are not
sure of them, consult your local dealer/retailer. Be sure to seal the drum
unit tightly so that toner powder does not spill out of the unit. Do not
discard used drum units with domestic rubbish.
It is recommended to put the drum unit on a piece of disposable paper or
cloth in case of accidental toner spill or scatter.
High Temperature
Fig. 5-11 Inside the Printer
"REPLACING THE TONER
CHAPTER 5 MAINTENANCE
CHAPTER 5 –7