Connecting The Serial Interface Cable - Brother HL-1060 Series User Manual

USER'S GUIDE

Connecting the Serial Interface Cable

CHAPTER 4 –4
Table 3: Parity Settings
Selector 1 Selector 2
On On
On Off
Off —
Note
The factory settings are indicated in bold.
If the robust Xon setting is turned on with selector 8, the printer sends
Xon signals at one second intervals to the connected computer until it
receives data. It is effective only if selector 7 is set to the On position for
the Xon/Xoff plus DTR setting.
Note
This section is only for printer models which have had the serial interface
installed.
You need a serial interface cable with an 8-pin, DIN-type connector to
connect your printer and computer.
Note
Consult your dealer for a serial interface cable.
If you are a Macintosh user, you can easily find the necessary cable at a
local computer store. Look for Apple serial cables labeled as
"Macintosh to ImageWriter II or "Macintosh to Personal
LaserWriter 300" or the "Apple System Peripheral 8 Cable". Do not
purchase a serial cable labeled as "Straight-through" or
"LocalTalk."
If you are a PC user, you need to purchase a special serial cable from
your dealer. If you have a 9-pin connector on your computer, look for a
cable labeled "IBM AT to ImageWriter II" cable. If you have a 25-pin
connector, look for a cable labeled "DB25 to ImageWriter II." These
cables most likely would be found in the Apple Macintosh section at
your computer dealer. For more information about the interface
specification, consult your dealer.
Parity
Odd
Even
None