Mattel Monster Maker Manual page 7

5
Slide the carriage into the Monster Maker until you hear a click.
6
Close the latch.
7
The design software shows you which marker to install. Remove the cap and install the marker in the holder as shown.
a b
Markers may stain fabrics and other surfaces. Avoid
contact with carpet, clothing, walls and furniture.
C
12
8
Close the door. The Monster Maker will not print if the door is open.
If your design includes more than one color, change markers when prompted by the design software. Replace the marker cap
and put it back in the tool holder, cap side down. After printing is complete, open the door, remove the marker, and take the
doll part out by reversing the steps above.
Remove the dark purple adapter by pushing it out of the slide.
Store adapters in the tool stand.
13