Getting Ready To Print - Mattel Monster Maker Manual

Getting ready to print

1
Open the door.
2
Lift the latch.
3
a. Press and hold the release button on the front of the carriage. b. Slide the carriage out of the Monster Maker.
8
4
Find the doll part you want to print below. Follow the steps to assemble adapters to the doll part and load it in the carriage.
Each adapter is marked with the shapes of the doll part it goes with.
Head
a. Connect adapter to the head.
b. Snap adapter into the slide.
c. Move slide to the left until the arrow is pointing at the head icon. Connect the head to the carriage.
Torso
a. Snap adapter to the torso.
b. Snap adapter to the slide.
Back View
c. Move slide to the left until the arrow is pointing at
the torso icon. Connect the torso to the carriage.
9