Table of Contents
Advertisement
9.2
Placement and replacement of the reflector
Warning! Always allow for a cool down period of at least 30 minutes before
touching the lamp or reflector.
Avertissement! Toujours prévoir une période de refroidissement d'au moins 30 minutes
avant de toucher la lampe ou le réflecteur.
Note: Gavita recommends replacing the reflector* after 5000 lighting hours.
Depending on the environment and contamination levels the reflector will degrade.
The Vega/Miro™ aluminum can not be cleaned without damage. Therefore we
recommend to change the reflector once every year. Also replace the lamp when
replacing the reflector.
* The reflector is delivery dependent, it may differ from the image.
•
Switch off mains power.
•
Remove the lamp from the fixture (see paragraph 10.1).
•
Support the reflector on the side of the reflector lever to prevent it from falling
(15).
•
Move the reflector lever up to retract the two pins holding the reflector in place
(16).
•
Remove the reflector (17).
•
Place the new reflector. Ensure the reflector lever is in the opened position to
allow the reflector to pass.
•
Ensure the holes in the reflector are aligned with the pins in the fixture (18).
•
Release the reflector lever so its two pins hold the reflector in place.
•
Insert the lamp in the lamp holder (see paragraph 10.1).
•
Switch on mains power.
10
Storage and disposal
•
Store the fixture in a dry and clean environment, with an ambient temperature of
-20 ~ 85 °Celsius / -4 ~ 185 °Fahrenheit.
•
The product must not be discarded as unsorted municipal waste, but must be
collected separately for the purpose of treatment, recovery and environmentally
sound disposal.
Caution! The lamps are chemical hazardous waste and must be delivered to the
designated authorities.
Mise en garde! Les lampes constituent des déchets chimiques dangereux et
doivent être livrées aux autorités compétentes.
Caution! The lamp contains mercury.
Mise en garde! La lampe contient du mercure.
15.
16.
17.
18.
Advertisement
Table of Contents
