Installation - Gavita Pro SL2 Series Manual

Table of Contents

Advertisement

5
Contents (1)
A.
Gavita SL2 1000e 208-240 V fixture
1. Electronic ballast
2. Pro-line bracket
3. Lever to unlatch reflector
4. Lamp sockets
5. Reflector Gavita HR96 DE*
6. Mounting points
*The reflector is delivery dependent,
it may differ from the image
B.
Gavita Pro Plus 1000 W EL 400 V lamp*
Lamp may vary depending on fixture
C.
Interconnect cable (RJ/RJ )
Cable length: 2.5 m / 8 ft
D.
Power cord with NEMA 6-15P plug
E.
Dummy plug
6
Controls, connections and
indications (2)
A.
IEC C13 connection
B.
Gavita 2xRJ connector
1. RJ IN
2. RJ OUT
C.
Status LED
7
Installation / Installation
Warning! Avoid coiled cords. Coiled cords may lead to electromagnetic interference.
Avertissement! Évitez que les cordons ne s'enroulent. Les cordons enroulés peuvent causer des interférences
électromagnétiques.
Warning! Always install the lamp before connecting the fixture to the mains.
Avertissement! Toujours installer une lampe avant de brancher le dispositif au conducteur principal.
Warning! When connecting the fixture to the controller it may ignite. Make sure either power is disconnected or the
controller is switched off.
Avertissement! Le dispositif peut s'enflammer lors du branchement au régulateur. Assurez-vous d'éteindre l'alimentation
ou d'éteindre le régulateur.
Warning! Ensure the local cabling can support the voltage and current requirements of the fixture.
Avertissement! Assurez-vous que le câblage local peut soutenir la tension et les exigences actuelles du dispositif.
7.1
Preparing the fixture for use
Switch off mains power.
Install the lamp in the fixture (see paragraph 10.1).
Hang the lamp by its two mounting points (3). The mountings point are spaced 407 mm / 16 inches apart.
These fixtures are intended to be hung in the open with
adequate space around the fixture. In the case of limited space
be sure to provide at least 6 inches to any combustible ceiling
and 12 inches to any combustible wall or partition, and at least
24 inches between fixtures. This will prevent overheating of
both the lighting fixture and any combustible structure within
the installation environment.
A6
A5
A1
C E
B
1.
B2
B1
B
C
2.
3.
C C
A3
A2
A4
D
A
Gavita 2xRJ
407 mm / 16 inch
750W
1000W
0.75 m -
30 in
4.
Gavita
HR96 DE
Gavita
Intensity
Optic
Gavita W
150 DE
NEMA
6-15P
1 m -
40 in

Advertisement

Table of Contents
loading

Table of Contents